Endress+Hauser ria45 - Page 63

RIA45 Appendix
Endress+Hauser 63
Description Configures the 100%-value for the bar graph
User entry Numerical value
1)
Factory setting 100
Factor
Navigation

Setup → Calc value 1/Calc value 2 → Factor
Description Setting of factor for calculated value
User entry Numerical value
1)
Factory setting 1.0
Offset
Navigation

Setup → Calc value 1/Calc value 2 → Offset
Description Configures an offset
User entry Numerical value
1)
Factory setting 0
No. lin points
Navigation

Setup → Calc value 1/Calc value 2 → No. lin points
Description Number of points for linearization.
User entry 2…32
Factory setting 2
Additional information Only visible if "Calculation" = "Linearization" was set.
X-value
Navigation

Setup → Calc value 1/Calc value 2 → X-value
Description For entering the points for linearization (max. 32)
User entry X-value 1...X-value 32, numerical value
1)
Factory setting 0
Additional information Only visible if "Calculation" = "Linearization" was set.
Y-value
Navigation

Setup → Calc value 1/Calc value 2 → Y-value
Description For entering the points for linearization (max. 32)
User entry Y-value 1...Y-value 32, numerical value
1)
Factory setting 0
Additional information Only visible if "Calculation" = "Linearization" was set.
Reset min/max
Navigation

Setup → Calc value 1/Calc value 2 → Reset min/max