Endress+Hauser ria45 - Analog Output Configuration

Appendix RIA45
64 Endress+Hauser
Description Resets the min./max. values saved.
Options no
yes
Factory setting no
Submenu "Analog Out 1"/"Analog Out 2"
Navigation

Setup → Analog Out 1/Analog Out 2
Additional information Settings for analog output 1 or analog output 2
Assignment
Navigation

Setup → Analog Out 1/Analog Out 2 → Assignment
Description Selects the source for the output signal
Options off
Analog 1
Analog 2
Calc Val 1
Calc Val 2
Factory setting off
Signal type
Navigation

Setup → Analog Out 1/Analog Out 2 → Signal type
Description Selects the type of signal for the output signal
Options 4-20mA
0-20mA
0-10V
2-10V
0-5V
1-5V
Factory setting 4-20mA
Lower range
Navigation

Setup → Analog Out 1/Analog Out 2 → Lower range
Description Configures the measuring range lower limit
User entry Numerical value
1)
Factory setting 0
Upper range
Navigation

Setup → Analog Out 1/Analog Out 2 → Upper range
Description Configures the measuring range upper limit
User entry Numerical value
1)
Factory setting 100