Operation RMS621
24 Endress+Hauser
5.1.1 Display
Fig. 17: How the display of the energy computer appears
Item: 1: measured value display
Item: 2: display of configuration menu item
– A: row of key icons
– B: current configuration menu
– C: configuration menu activated for selection (highlighted in black).
5.1.2 Key icons
5.2 Local operation
5.2.1 Entering text
There are two ways of entering text in the operating items (see: Setup → Basic set-up→ Text
input):
a) Standard: individual characters (letters, numbers, etc.) in the text field are defined by scrolling
through the entire row of characters with the up/down cursor until the desired character is
displayed.
b) Palm: a visual key field appears for entering text. The characters on this keyboard are selected
with the cursors. (see "Setup Æ Basic set-up")
Key icon Function
E Change to submenus and select operating items. Edit and confirm configured values.
Z Exit the current editing mask or the menu item currently active without saving any
changes.
↑ Move the cursor up a line or a character.
↓ Move the cursor down a line or a character.
→ Move the cursor a character to the right.
← Move the cursor a character to the left.
? If Help text is available on an operating item, this is indicated with the question mark. The
Help is called up by actuating this function key.
ΑΒ Change to the editing mode of the Palm keyboard
ij/iJ Key field for upper case/lower case (only with Palm)
½ Key field for numerical entries (only with Palm)
To Next Page
Loading...
