Endress+Hauser RMS621 - Device Configuration and Navigation

RMS621 Commissioning
Endress+Hauser 29
Error messages
After switching on or configuring the device, the message "Communication problem" appears
briefly on the remote display/operating unit until a stable connection has been established.
If this error message is displayed during operation, please check the wiring to the Energy Manager
and ensure that the baudrate and the device address match the Energy Manager.
6.3 Device configuration
This section describes all the configurable device parameters with the associated value ranges and
factory settings (default values).
Please note that the parameters available for selection, e.g. the number of terminals, depend on the
device version (see Section 6.2.2 Extension cards).
Function matrix
Fig. 22: Function matrix (extract) for on-site Energy Manager configuration. A detailed function matrix can be found in
the Appendix.
6.3.1 Navigator (quick start)
Fig. 23: Quick start to configuration via the Navigator menu of the Energy Manager.
In the operating mode of the Energy Manager (measured value displayed), the operating window
"Navigator" opens up by pressing any key: the Navigator menu offers quick access to important
information and parameters. Pressing one of the keys available takes you directly to the following
items:
Display
Navigator
Groups
Error list
Counter val
Menu
Diagnosis
Terminal info
Event buffer
Setup (all
parameters)
Basic set-up
Outputs
Inputs
(T, p, V etc.)
Program-
Info
Applications
Communi-
cation
Display
Service