Endress+Hauser RMS621 - Main Menus: Diagnosis and Setup

Commissioning RMS621
30 Endress+Hauser
The contents of the groups with display values can only be defined in the Setup → Display menu.
A group comprises a maximum of eight process variables which are displayed in a window in the
display. When commissioning the device, 2 groups with the most important display parameters are
automatically created when an application is selected. Automatically created groups are also marked
with a value in brackets (A1..3) which refers to the application, e.g. Group 1 (A1) means Group 1
with display values for Application 1.
The settings for the display functionalities, e.g. contrast, scrolling display, special groups with display
values etc. are also made in the menu Setup → Display.
!
Note!
When commissioning, the prompt "Please set up device" is displayed. Confirming this message
takes you to the Navigator menu. Select ’Menu’ here to get to the Main menu.
A device already configured is in the display mode as standard. The device changes to the Navigator
menu as soon as one of the eight operating keys is pressed. From here, you get to the Main menu
by selecting ’Menu’.
!
Note!
If you continue navigating through the Main menu, the message "If you change the application,
the respective counters will be reset" is displayed. Confirming this message takes you to the
Main menu.
6.3.2 Main menu - Diagnosis
The Diagnosis menu is used to analyse the device functionality, such as locating device
malfunctions.
Function (menu item) Description
Group For selecting individual groups with display values.
Display For displaying the groups alternately, setting in the setup menu"Display".
Error list For quickly localising current device errors.
Counter val For reading off and, if necessary, resetting all the totalizers.
Menu Main menu for configuring the device.
Function (menu item) Parameter setting Description
Terminal info A10 Lists all the terminals of the device and the connected sensors.
Display the signal values present (in mA, Hz, Ohm) by pressing
the
key i.
Event buffer Log of all the events, e.g. error messages, parameter changes,
etc. in chronological order. (ring buffer with approx. 100
values, cannot be deleted!)
Program info Displays the device data such as program, name, software
version, date and time.