Commissioning RMS621
38 Endress+Hauser
Range 1 (2, 3) start 0.0000 to 999999 Start value for the differential pressure at 0 or 4 mA, defined
for the pressure transmitter in range 1 (2, 3)
!
Note!
Only active after a terminal has been assigned.
Range 1 (2, 3) end 0.0000 to 999999 End value for the differential pressure at 20 mA, defined for the
pressure transmitter in range 1 (2, 3)
!
Note!
Only active after a terminal has been assigned.
Correction Yes
No
Possibilities for correcting the flow measurement by offset,
signal damping, flow cut off, sensor expansion coefficient and
correction table for curve description.
see Setup ’Differential pressure transmitter’
Pipe data Units (mm/inch)
Inner dia.
Geom. ratio
K-factor
See Setup ’Differential pressure transmitter’.
Sums Unit
Format
Actual
Total
Signal reset
Terminals
See Setup ’Flow inputs’.
Alarm response See Setup ’Flow inputs’.
Mean flow
Identifier Mean flow Name for computing the mean value from several flow signals
(max. 12 characters).
Number Unused
2 sensors
3 sensors
Mean value computed from several flow signals
(See Section 11.2.1 for details of the 'Mean value
computation')
Sums Unit
Format
Actual
Total
Signal reset
Terminals
See Setup ’Flow inputs’.
Function (menu item) Parameter setting Description
To Next Page
Loading...
