SS2100i-2 TDLAS Gas Analyzer Operating Instructions
Endress+Hauser 25
4 Installation
This section describes the processes used to initially install and configure your SS2100i-2. Once the analyzer arrives,
you should take a few minutes to examine the contents before installing the unit.
4.1 What should be included in the shipping box
The contents of the crate should include:
• The Endress+Hauser SS2100i-2 analyzer
• SS2100i-2 Safety Instructions (XA02694C)
• Tooling kit (P/N 1100002156)
If any of these contents are missing, contact your sales representative.
4.2 Lifting/carrying the analyzer
The SS2100i-2 is bolted on a Unistrut
®
(or equivalent) metal frame in the factory. Due to the analyzer’s size and
weight (approximately 145 Kg [320 lbs], without sample conditioning system) Endress+Hauser recommends the use
of a forklift, pallet jack, etc. to lift and/or move the analyzer.
Before removing from the crate, move the analyzer as close as possible to the final installation location. Always carry
the load using the lifting eyes (refer to Fig 16 → and the drawings included with the purchased SS2100i-2
analyzer).
Ensure all equipment used for lifting/moving the analyzer is rated for the maximum weight load.
4.3 Inspecting the analyzer
Unpack and place the unit on a flat surface. Carefully inspect all enclosures for dents, dings, or general damage.
Inspect the inlet and outlet connections for damage, such as bent tubing. Report any damage to the carrier.
Avoid jolting the instrument by dropping it or banging it against a hard surface, which may disturb the optical
alignment.
Fig 16. SS2100i-2 mounting and dimensions.
1. 1270 mm (50 in) 4. 4 x Ø 15.88 mm (0.65 in) A. Mounting eyebolts
2. 1219.20 mm (48 in) 5. 541.28 mm (21.3 in)
3. 184.15 mm (7.25 in) (min) 6. 500 mm (19.7 in)
To Next Page
Loading...
