Endress+Hauser SS2100i-2 - Specifications

SS2100i-2 TDLAS Gas Analyzer Operating Instructions
Endress+Hauser 39
5 Specifications
Performance
Concentration
See analyzer calibration report
Repeatability
See analyzer calibration report
Measurement time
1
Typically less than 20 seconds
Application data
Environmental temperature range
–20 C to 50 C (–4 F to 122 F) — Standard
–30 C to 60 C (–14 F to 140 F) — Optional
Heated enclosure temperature
50  5 C
Shipment and storage temperatures
≥ –20 °C (–4 °F) — Standard
> 0 °C (32 °F) — Analyzers with perm tube validation
Environmental relative humidity
5% to 95%, Non-condensing
Altitude
Up to 2000 m
Sample cell operating pressure range
800 to 1200 mbar — Standard; 950 to 1700 mbar — Optional
Pressure to cell
70 kPaG (10 PSIG) max to spectrometer cell
Sample flow rate
0.5 to 4 SLPM (0.02 to 0.1 SCFM)
1
Contaminant sensitivity
None for gas phase glycol, methanol, amines, or mercaptans
Electrical & communications
Input power, maximum
2
120 or 240 VAC ± 10%, 50 to 60 Hz standard; ~300 W
1
Communications
Analog: Isolated Analog channels, 1200 ohms at 24 VDC max
Outputs: Qty (2) 4 to 20 mA (measurement value)
Input: Qty (1) 4 to 20 mA (pipeline pressure)
1
Serial: Ethernet and RS-485 half-duplex — Standard
Digital signals
Outputs: (5); Hi/Lo Alarm, General Fault, Validation Fail
1
, Validation 1 Active
1
,
Validation 2 Active
1
Inputs: (2); Flow Alarm
1
, Validation Request
1
Protocol
Modbus Gould RTU, Daniel RTU or ASCII
Diagnostic value examples
Detector Power (Optics Health), Spectrum Reference Comparison and Peak Tracking
(Spectrum Quality), Cell Pressure and Temperature (Overall System Health)
LCD display
Concentration, Cell Pressure, Cell Temperature, and Diagnostics
Physical specifications
Electronics enclosure
IP66 Copper-free Aluminum with Weather-resistant Polyurethane Powder Coating, 80 to
120 micron thickness
Sample system enclosure(s)
IP55 (min.) 304 or 316L Stainless Steel
Dimensions
3
670 mm H ´ 1270 mm W ´ 248 mm D (26.3 in H x 50 in W x 9.7 in D)
Weight
3
Approximately 145 kg (320 lbs) (not including Sample Conditioning System)
Sample cell construction
316L Series Polished Stainless Steel — Standard
1
Application dependent.
2
Supply voltage not to exceed +10% of nominal. Transient over-voltages according to Over-voltage category II.
3
Dimensions are for analyzer only. Consult system drawings for analyzers with sample conditioning systems.