Operating Instructions SS2100i-2 TDLAS Gas Analyzer
62 Endress+Hauser
8. Close any valves controlling the sample flow effluent to the low-pressure flare or atmospheric vent.
9. Disconnect power to the system.
10. Disconnect all tubing and signal connections.
11. Cap all inlets and outlets to prevent foreign material such as dust or water from entering the system.
12. Pack the equipment in the original packaging in which it was shipped, if available. If the original packaging
material is no longer available, the equipment should be adequately secured (to prevent excessive shock or
vibration).
13. If returning the analyzer to the factory, complete the Decontamination Form provided by Service and attach to
the outside of the shipping package as instructed before shipping.
6.13 Storage
The packaged analyzer should be stored in a sheltered environment that is temperature controlled between –20
o
C
(–4
o
F) and 50
o
C (122
o
F), and should not be exposed to rain, snow, caustic, or corrosive environments. Humidity in
the sheltered environment should be non-condensing.
6.14 Disclaimers
Endress+Hauser accepts no responsibility for consequential damages arising from the use of this equipment. Liability
is limited to replacement and/or repair of defective components.
This manual contains information protected by copyright. No part of this guide may be photocopied or reproduced in
any form without prior written consent from Endress+Hauser.
6.15 Warranty
For a period of 18 months from date of shipment or 12 months in operation, whichever comes first, Endress+Hauser
warrants that all products sold by it shall be free from defects in material and workmanship under normal use and
service when correctly installed and maintained. Endress+Hauser’s sole liability and Customer’s sole and exclusive
remedy for a breach of warranty is limited to Endress+Hauser’s repair or replacement (at Endress+Hauser’s sole
option) of the product or part thereof which is returned at Customer’s expense to Endress+Hauser’s plant. This
warranty shall apply only if Customer notifies Endress+Hauser in writing of the defective product promptly after the
discovery of the defect and within the warranty period. Products may only be returned by Customer when
accompanied by a return authorization reference number (SRO) issued by Endress+Hauser. Freight expenses for
products returned by Customer will be prepaid by Customer. Endress+Hauser shall pay for shipment back to
Customer for products repaired under warranty. For products returned for repair that are not covered under
warranty, Endress+Hauser’s standard repair charges shall be applicable in addition to all shipping expenses.
To Next Page
Loading...
