SS2100i-2 TDLAS Gas Analyzer Operating Instructions
Endress+Hauser 7
Hazards may vary by stream composition. One or more of the following conditions may apply.
Flammable. Gases used in the processing of this analyzer may be extremely flammable. Any work in a hazardous
area must be carefully controlled to avoid creating any possible ignition sources (e.g., heat, arcing, sparking, etc.).
Toxins. Endress+Hauser analyzers measure a variety of gases, including high-level H
2
S. Follow all safety protocols
governing toxic gases and potential leaks.
Inhalation. Inhaling toxic gases or fumes may cause physical damage or death.
Technicians are expected to follow all safety protocols established by the customer that are necessary for
servicing or operating the analyzer. This may include, but is not limited to, lockout/tagout procedures, toxic gas
monitoring protocols, personal protective equipment (PPE) requirements, hot work permits and other
precautions that address safety concerns related to performing service or operation on process equipment
located in hazardous areas.
2.2.2 Equipment labels
Warning statement for hazardous voltage. Contact may cause electric shock or burn. Turn off and lock out system
before servicing.
Failure to follow all directions may result in damage or malfunction of the analyzer.
Maximum voltage and current specifications for the fuse closest to label.
PROTECTIVE EARTH GROUND — Symbol indicates the connection point of the ground wire from the main power
source.
FUNCTIONAL EARTH GROUND — Symbol indicates grounding points intended primarily for troubleshooting.
2.2.3 Instructional symbols
General notes and important information concerning the installation and operation of the analyzer.
Failure to follow all directions may result in fire.
INVISIBLE LASER RADIATION — Avoid exposure to beam. Class 3b Radiation Product. Refer servicing to the
manufacturer-qualified personnel.
Failure to follow all directions may result in damage or malfunction of the analyzer.
Maximum voltage and current specifications for fuses.
To Next Page
Loading...
