8.5 Wireless MAC Filter
Wireless MAC Filters are used to allow or deny network access to wireless clients according
to their MAC addresses. You can manually add a MAC address to restrict the permission to
access ENH200. The default setting is Disable Wireless MAC Filters.
0.
ACL Mode
Determines whether network access is granted or denied to
clients whose MAC addresses appear in the MAC Address table
on this page. Choices are Disable, Deny MAC in the list, or
Allow MAC in the list.
MAC Address Filter
Enter the MAC address of the device.
Add
Click Add to add the MAC address to the MAC Address table.
Apply
Click Apply to apply the changes.
To Next Page
Loading...
