SecureStack A2 Installation Guide xiii
About This Guide
Thisguideprovidesanoverviewofinstallation,troubleshooting,andspecificationsfor
theEnterasys
®
SecureStackA2H254‐16stackableEthernetswitch.
Forinformationab outtheCommandLineInterface(CLI)setofcommandsusedto
configureandmanagetheswitch,refertotheEnterasys
Networks
®
SecureStackA2
ConfigurationGuide.
Who Should Use This Guide
Thisguideisintendedfor anetworkadministratorresponsibleforinstallingandsetting
upthestackableswitches.
Note: In this guide, the following terms are used:
• Switch refers to an A2H254-16unless otherwise noted.
• MGBIC (Mini-Gigabit Interface Card) refers to optional small form plugable (SFP)
interface modules that plug into the fixed front panel MGBIC slots.
Important Notice
Depending on the firmware version used in the A2H254-16 switch, some features described in this
document may not be supported. Refer to the Release Notes shipped with the SecureStack A2 to
determine which features are supported.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.
To Next Page
Loading...
Need help?
General