EasyManua.ls Logo

Enterasys SecureStack A2 A2H254-16 - Configuring Switches in a Stack

Enterasys SecureStack A2 A2H254-16
80 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuring Switches in a Stack
3-12 Hardware Installation
Figure 3-8 Stacking Cable Connections
Afterconnectingthecablestothestackingports,proceedto “ConfiguringSwitchesina
Stack”onpage3‐12forinstructions.
Configuring Switches in a Stack
Theinformationinthefollow ingsectionsisimportanttounderstandA2switchoperation
andinstallationsinastackinstallation.
About SecureStack A2 Switch Operation in a Stack
TheSecureStackA2productsarestackablesw itchesthatcanbeadaptedand scaledto
helpmeetyournetworkneeds.Theseswitchesprovideamanagementplatformand
uplinktoanetworkbackboneforastackedgroupofuptoeight
A2switches.
1 Category 5 or better UTP cable 4 STACK UP connector at top of stack
2 STACK UP connector 5 STACK DOWN connector at bottom of stack
3 STACK DOWN connector

Table of Contents

Related product manuals