Enterasys SecureStack A2 A2H254-16 - Using the Reset Password Button

Using the Reset Password Button
4-8 Troubleshooting
Using the Reset Password Button
IfyouforgettheSecureStackA2loginpassword,usetheResetPasswordbuttonas
describedinthefollowingprocedure.
Figure 4-2 Reset Password Button
ToresettheSecureStackA2password,refertoFigure4‐2andproceedasfollows:
1. Press‐and‐holdtheResetPasswordbuttonwhiletheswitchisoperational.This
changeoftheloginpasswordtothedefaultpasswordwillbeindicatedviaLocal
ManagementCLIonly.ThisinformationwillnotshowupinaTelnetsession.
2. Logontoswitchmanagement.Youcannowlogontotheswitch
viatheConsoleport
andassignanewpasswordusingthecommandlineinterface(CLI).
3. Toaccessswitch managementfromyourlocalPC,terminal,ormodemconnection,
refertotheSecureStackA2ConfigurationGuideforinstructionsonhowtologinand
enteranewpassword.Theguideisavailableonline
undertheScategoryfor
Securestackat:
http://www.enterasys.com/support/manuals
Ifyourequireassistance,contactEnterasysNetworksusingoneofthemethodsdescribed
in
“GettingHelp”onpage1‐6.
1 Reset Password button
Note: Notify the system manager before changing the password.
Console
CPU
RPS
MGR
À