6 Installing an nShield Connect in a rack, cabinet, or shelf
6 Installing an nShield Connect in a
rack, cabinet, or shelf
This chapter describes how to install the nShield Connect. For more information about connecting the
nShield Connect to the network, and configuring it for connection to one or more clients on the
network, see the
nShield Connect User Guide
.
Always handle modules correctly. For more information, see
Handling an nShield Connect
on
page 12.
Take due account of the weight and dimensions of the nShield Connect when selecting a
location for storage or installation ( see
Handling an nShield Connect
on page 12).
You cannot install or configure the nShield Connect remotely.
To install the nShield Connect in a 19” rack, follow the instructions supplied with your rack mounting
kit.
To install the nShield Connect in a cabinet or a shelf, fit the four self-adhesive rubber feet (supplied
with the HSM) to the bottom of the HSM. An X is scored into the chassis at each of the four corners on
the bottom of the HSM as a guide to placing the feet.
nShield® Connect - Installation Guide
Page 31
To Next Page