Entrust nShield Connect v12.50.4 - Set up Routing; Set up Routing for Ipv4

9.2.5 Set up Routing
1. From the front panel menu, select System > System configuration > Network config > Set
default gateway > IPv6 gateway.
The following screen is displayed:
Gateway configuration
Enter IPv6 address of
the default gateway:
::
CANCEL NEXT
Enter the address for the gateway. Press the right-hand navigation button. The following screen is
displayed if the address entered was a link-local address:
Gateway configuration
Select an interface
for link-local address:
fe80:xxxx:xxxx:xxxx:
xxxx:xxxx:xxxx:xxxx
Interface #1
CANCEL NEXT
Select the interface for the IPv6 gateway. Press the right-hand navigation button to accept.
9.2.5 Set up Routing
9.2.5.1 Set up routing for IPv4
To set a new route entry for IPv4:
1. From the front panel menu, select System > System configuration > Network config > Set up
routing > New IPv4 route entry.
The following screen is displayed:
Edit route entry
Enter IP range
and mask length:
0. 0. 0. 0/ 0
Enter the gateway:
0. 0. 0. 0
CANCEL FINISH
2. Enter the IPv4 address range details for the route. Press the right-hand navigation button to
accept.
nShield® Connect - Installation Guide
Page 50