Appendix A Uninstalling existing software
A.2.3 Uninstalling on HP-UX
To uninstall the Security World Software from HP-UX:
1. Assume the nFast Administrator privileges or root privileges by running the command:
su -
2. Type your password, then press Enter.
3. To remove drivers, install fragments, and scripts and to stop services, run the command:
/opt/nfast/sbin/install -u
4. Remove the software packages by running the command:
/usr/sbin/swremove
The command displays the list of components that were installed.
5. Select all the nCipher packages.
6. Select Remove from the Actions menu.
7. When the analysis is complete, if there are no errors, click OK. If the installer reports any errors,
click Logfile to display them.
8. When the uninstaller asks you to confirm that you want to remove this product, click Yes.
9. When the uninstallation is complete, click Done.
10. If you are not planning to re-install the product, delete the configuration file /etc/nfast.conf if it
exists.
Do not delete the configuration file if you are planning to re-install the product.
If required, you can safely remove the module after shutting down all connected hardware.
A.2.4 Uninstalling on Linux
To uninstall the Security World Software from Linux:
1. Assume the nFast Administrator privileges or root privileges by running the command:
$su -
2. Type your password, then press Enter.
Page 75
Connect -
Installation Guide
To Next Page