Entrust nShield Connect v12.50.4 - Enable;Disable Ipv6; Set up Ipv6 Static Address

9 Basic nShield Connect, RFS and client configuration
9.2.2.3 Enable/disable IPv6
To enable/disable IPv6:
1. From the front panel menu, select System > System configuration > Network config > Set up
interface #1 > Configure #1 IPv6 > IPv6 Enable/Disable.
The following screen displays:
Network configuration
IPv6 enable/disable:
DISABLE
CANCEL FINISH
2. Set the ENABLE/DISABLE field to the required option.
3. To accept, press the right-hand navigation button.
9.2.2.4 Set up IPv6 static address
To set up IPv6 static address:
1. From the front panel menu, select System > System configuration > Network config > Set up
interface #1 > Configure #1 IPv6 > Static IPv6 address > IPv6 address entry.
The following screen displays:
Network configuration
Enter IPv6 address
For interface #1:
::
CANCEL NEXT
2. Enter the required IPv6 address.
3. When the IPv6 address is correct, press the right-hand navigation button. The following screen
displays:
Network configuration
IPv6 address
xxxx:xxxx:xxxx:xxxx:
xxxx:xxxx:xxxx:xxxx
Enter prefix length:
64
BACK NEXT
4. When the IPv6 address prefix details are correct, press the right-hand navigation button.
Page 47
nShield® Connect - Installation Guide