9 Basic nShield Connect, RFS and client configuration
9.2.5.2 Set up routing for IPv6
To set a new route entry for IPv6:
1. From the front panel menu, select System > System configuration > Network config > Set up
routing > New IPv6 route entry.
The following screen is displayed:
Edit route entry
Enter the IP range
and prefix length:
::/64
CANCEL NEXT
2. Enter the IPv6 address range details for the route. Press the right-hand navigation button to
accept. The following screen is displayed:
Edit route entry
xxxx:xxxx:xxxx:xxxx:
xxxx:xxxx:xxxx:xxxx
/xxx
Enter the gateway:
::
BACK NEXT
3. Enter the gateway address; if it is a link local address, the following screen is displayed.
Edit route entry
Select an interface
for link-local address:
fe80:xxxx:xxxx:xxxx:
xxxx:xxxx:xxxx:xxxx
Interface #1
BACK NEXT
4. Select the interface for the IPv6 gateway and press the right-hand navigation button to accept.
5. If the new route entry entered for IPv6 is incorrect an error message is displayed on the next
screen, select BACK to go to the route entry screen. The new IPv6 route entry will need to be
entered again.
Page 51
nShield® Connect - Installation Guide
To Next Page