9 Basic nShield Connect, RFS and client configuration
1. From the front panel menu, select System > System configuration > Network config > Set up
interface #2.
2. Enter the details for interface #2 in the same manner that you entered the details for interface
#1.
3. Once the interface #2 details have been entered you need to explicitly enable interface #2.
Select System > System configuration > Network config > Set up interface #2 >
Enable/Disable Int #2 .
4. The following screen displays:
Network configuration
Interface #2
DISABLE
CANCEL FINISH
5. Select the ENABLE option.
6. Press the right-hand navigation button to accept, and a screen similar to that used for interface
#1 is displayed.
9.2.4 Default gateway
9.2.4.1 Set default gateway for IPv4
To set a default gateway for IPv4:
1. From the front panel menu, select System > System configuration > Network config > Set
default gateway > IPv4 Gateway.
The following screen is displayed:
Gateway configuration
Enter IPv4 address of
the default gateway:
0. 0. 0. 0
CANCEL NEXT
2. Enter the IPv4 address of the default gateway.
3. Press the right-hand navigation button NEXT and then FINISH to accept.
9.2.4.2 Set default gateway for IPv6
To set a default gateway for IPv6:
Page 49
nShield® Connect - Installation Guide
To Next Page