Sigma DS1, DS2, and DS3 Card Printers Installation and Administrator’s Guide 5
Clearance Requirements
The following measurements show the printer dimensions when the input hopper and printer
cover are open and the power cord is connected. Provide at least 3 inches (76.2 mm) of additional
clearance around the system to maintain access to the power cord and data cables, to load and
remove cards and supplies, and to provide ventilation.
Single-Hopper Printer
Options, such as additional components, change the dimensions of the printer.
Additional clearance is required when using these options.
13.1 in
333 mm
17.5 in
444 mm
21.9 in
556 mm
10.9 in
277 mm
4.2 in
107 mm
17.5 in
444 mm
To Next Page
Loading...
