Entrust Sigma DS3 Installation And Administrator's Guide

8 Printer Installation
Set Up the Printer
Use the information in the following sections to set up the printer to print cards.
Unpack the Printer
1. Remove the accessories tray and printer from the shipping carton.
The accessories tray holds the printer power supply and power cord, a print ribbon, keys (for
locking printers), cleaning swabs, USB-C Cable and a USB flash drive. The flash drive contains
the QuickInstaller and user documentation.
2. Place the printer on the selected work surface. Make sure that the surface meets the
requirements described in “Site Requirements” on page 3.
Save the shipping cartons and packing materials. They are required if you need
to store, move, or return the system for service.

Entrust Sigma DS3 Specifications

General

Print Resolution	300 dpi
Card Capacity Input Hopper	100 cards
Card Capacity Output Hopper	25 cards
Power Supply	100-240 VAC, 50/60 Hz
Print Technology	Dye sublimation
Print Capabilities	Single or dual-sided
Card Thickness	0.010 inches to 0.040 inches
Supported Card Sizes	CR80 (85.6 mm x 54 mm)
Connectivity	USB and Ethernet
Operating System Support	Windows 7, 8, 10, Server 2008, 2012, 2016
Weight	5.49 kg (12.1 lbs)
Operating Temperature	15°C to 35°C (60°F to 95°F)
Operating Humidity	20% to 80% (non-condensing)
Print Speed	Up to 250 cards per hour (YMCKT)