CAOut XX There is either short-circuit or a break in cabin
output no. XX. If the output is not in use, it has
to be removed from the error follow-up in the
"Cabin outputs" display.
Sensor voltage! Sensor voltage below 11 V. Error message is in
use if the sensor voltage control is in use, and if
the voltage in head module connector number
22 is more than 11 V during the system start-
up. Error is reset with "Saw" button. More
detailed information is in section "9.8 Sensor
voltage control".
Connection disturbance of the cabin module:
The contact to the cabin module is broken.
Check the voltages and the connections.
Connection disturbance of the grapple module:
The contact to the grapple module is broken.
Check the voltages and the connections.
CAN-bus disturbance: There is no connection to the cabin module nor
to the head module. Check the voltages and
the connections.
Error 2 Error in the checksum in the calibration data.
There might be errors in the length and
diameter calibration values.
Error 3 Error in the checksum in the settings.
There might be errors in the preselection data
etc.
Error 4 Error in the checksum in the statistics.
There might be errors in the statistics.
Error 10 Program error when writing.
The error can occur in some unusual untested
situations. Cannot be corrected, can only be by-
passed by restart. Contact the equipment
seller.
Error 11 Program error when reading.
The error can occur in some unusual untested
situations. Cannot be corrected, can only be by-
passed by restart. Contact the equipment
seller.
Error 15 Checksum error in the log statistics.
The second number is the number of the tree
species in question.
To Next Page
Loading...
Need help?
General