Epson AcuLaser C3900N - Page 143

This message... means... do this...
COVER OPEN
SIDE COVER
The printer’s right side cover is
open.
Close the right side cover.
COVER OPEN
TRAY3 COVER
The right side cover of Tray 3 is
open.
Close the right side cover of the tray.
HOLD JOB ERROR
UNABLE TO
STORE JOB
The specified print job saved on
the hard disk is sent while the
hard disk is not installed.
Print jobs can be saved only if a hard
disk is installed. If desired, install a
hard disk.
HOLD JOB ERROR
“OPTIONAL”
PRESS CANCEL
When printing a stored job, the
printer configuration was
changed since the job was
stored.
Change the printer configuration to
that when the job was stored.
MANUAL EMPTY
“SIZE”
“MEDIA”
Tray 1 was specified with the
printer driver as Manual Feed for
printing, but Tray 1 is empty.
Load the correct media into Tray 1.
MANUAL FEED
“SIZE”
“MEDIA”
The Paper Source in the printer
driver is set to Tray 1 (Manual
Feed), but there is already media
in the tray when printing begins.
Press the
key to print, or remove
and reload the media in Tray 1.
MEMORY FULL
PRESS CANCEL
The printer has received more
data than can be processed with
its internal memory.
Press the Cancel key to cancel the
print job.
Decrease the amount of data to be
printed, and then try printing again.
If that doesn’t solve the problem,
install an optional memory module.
NONGENUINE
TONER X
The installed toner cartridge is
not a genuine Epson product.
Installing a genuine toner cartridge is
recommended.
P/U END
REPLACE
X
The X photoconductor unit has
completely reached the end of its
life.
Replace the photoconductor unit.
P/U MISSING
CHECK X
The X photoconductor unit is not
installed, or an unapproved
photoconductor unit is installed.
Install a correct Epson
photoconductor unit.
PAPER EMPTY
“SIZE”
“MEDIA”
The specified tray is empty.
(Appears when PAPER MENU/
PAPER SOURCE/TRAY CHAINING
is set.)
Load the correct media into the
specified tray.
AcuLaser C3900 Series User’s Guide
Troubleshooting 143