277
Setting Options Description
Source Signal Format
Mic Input Level
Overscan
EDID
HDMI Out Intensity
Reset to Defaults
Signal Format: sets the signal type and
video range for certain input sources
• Video Signal: specifies the signal type
from video port input sources; if there is
interference or no image when set to
Auto, select the appropriate signal type
• Video Range: sets the video range to
match the setting of an HDMI or
HDBaseT (BrightLink 1485Fi+) input
source
Mic Input Level: adjusts the microphone
volume when audio is not output to an a/v
system; when this setting is turned up, the
other connected device's volume is turned
down, and vice versa
Overscan: changes the projected image
ratio to make the edges visible by a set
percentage or automatically when projecting
a component signal
EDID: describes the display capabilities of
your projector when the selected input
source is HDMI or HDBaseT (BrightLink
1485Fi+); change this setting as necessary
according to the current input source's
resolution; you can adjust settings for
individual input sources without changing
the input source
HDMI Out Intensity: adjusts the HDMI Out
port's signal intensity input; change this
setting when the image is not correctly
displayed from the HDMI Out port
Reset to Defaults: resets all settings for the
current input source
To Next Page
Loading...
