Epson DFX-9000 - Page 187

Epson DFX-9000 Field Repair Guide 3/29/07
Adjustments Printer Component, Software Item, LCD Display, Printer Button Page 178.
16. If a .38mm feeler gauge will not fit between the Print Head and the Platen, the gap is too narrow. Loosen Screw
C about 1/8 of a turn. To adjust the gap, insert a flat blade screwdriver into the opening to the right of Screw C.
Twist the screwdriver to change the gap. To increase the gap, move the Upper Angle Bar upwards. Tighten
Screw C when the adjustment is correct.
ScrewA
Screw B
Screw C
Upper Angle Bar