EasyManuals Logo

Epson EB-410W User Manual

Epson EB-410W
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
List of Functions
29
Extended Menu
Sub Menu Function
Display You can make settings related to the projector's display.
Messages: You can set whether to display (On) or not display (Off) the source name when you change the input source, the color mode name
when you change the Color Mode, a message when no image signal is input, and so on.
Display Background
*1
: You can set the screen status for when no image signal is available to "Black", "Blue", or "Logo".
Startup Screen
*1
: You can set whether the startup screen (the image projected when starting the projector) is displayed (On) or not (Off).
A/V Mute
*1
: You can set the screen displayed during A/V Mute as "Black", "Blue", or "Logo".
User's Logo
*1
You can change the user's logo that is displayed as a background and displayed during A/V Mute. s p.58
Projection You can choose one of the following settings according to the way the projector is setup. s p.49
Front" "Front/Ceiling" "Rear" "Rear/Ceiling"
You can change the setting as follows by pressing down the [A/V Mute] button on the remote control for about five seconds.
Front" W "Front/Ceiling"
Rear" W "Rear/Ceiling"
Operation Direct Power On: You can set whether Direct Power On is enabled (On) or disabled (Off).
When it is set to "On" and the projector power cable is connected to an electrical outlet, be aware that sudden surges of electricity may cause the
projector to turn on automatically.
Sleep Mode: When set to "On", this turns off the power automatically when no image signal is input and no operations are performed. Sleep
mode is set to (On) at the time of purchase.
Sleep Mode Timer: When Sleep Mode is set to "On", you can set how long the projector should wait before turning off the power from 1 to
30 minutes.
High Altitude Mode: Set this to "On" when using the projector above an altitude of 1500 m.
Standby Mode You can use network monitoring and control functions while the projector is in standby mode when this is set to "Network On".
You can use SNMP
g to monitor and control the status of the projector over the network, or by using the "EMP Monitor" software supplied with
this product.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson EB-410W and is the answer not in the manual?

Epson EB-410W Specifications

General IconGeneral
Matrix size0.56 \
Number of colors16.78 million colors
Projection distance0.62/7.83 m
Projection technologyLCD
Contrast ratio (typical)500:1
Screen size compatibility30 - 300 \
Projector native resolutionWXGA (1280x800)
Keystone correction, vertical-15 - 15 °
Throw ratio0.48 - 0.65:1
Focal length range6.48 mm
Lamp typeUHE
Lamp power170 W
Light source typeLamp
Service life of light source3000 h
Service life of light source (economic mode)4000 h
RMS rated power10 W
Number of built-in speakers1
Dimensions (WxDxH)258 x 327 x 95 mm
Power requirements100-240 V AC ± 10%, 50/60 Hz
Connectivity technologyWired
Serial interface typeRS-232
Noise level28 dB
Power consumption (standby)5.5 W
Power consumption (typical)236 W
Operating temperature (T-T)5 - 35 °C
Weight and Dimensions IconWeight and Dimensions
Weight3600 g

Related product manuals