Epson EB-410W User Manual

Replacing Consumables
52
Replacing the Lamp
f Lamp replacement period
It is time to replace the lamp when:
• The message "Replace the lamp." is displayed.
• The lamp indicator flashes orange.
• The projected image gets darker or starts to deteriorate.
A message is displayed.
Flashing orange
Attention
• The lamp replacement message is set to appear after the following
time periods in order to maintain the initial brightness and quality
of the projected images.
s "Brightness Control" p.28
·When used continually at high brightness: About 2900 hours
·When used continually at low brightness: About 3900 hours
• If you continue to use the lamp after the replacement period has
passed, the possibility that the lamp may explode increases. When
the lamp replacement message appears, replace the lamp with a
new one as soon as possible, even if it is still working.
• Depending on the characteristics of the lamp and the way it has
been used, the lamp may become darker or stop working before
the lamp warning message appears. You should always have a
spare lamp ready in case it is needed.

Epson EB-410W Specifications

General

Matrix size	0.56 \
Number of colors	16.78 million colors
Projection distance	0.62/7.83 m
Projection technology	LCD
Contrast ratio (typical)	500:1
Screen size compatibility	30 - 300 \
Projector native resolution	WXGA (1280x800)
Keystone correction, vertical	-15 - 15 °
Throw ratio	0.48 - 0.65:1
Focal length range	6.48 mm
Lamp type	UHE
Lamp power	170 W
Light source type	Lamp
Service life of light source	3000 h
Service life of light source (economic mode)	4000 h
RMS rated power	10 W
Number of built-in speakers	1
Dimensions (WxDxH)	258 x 327 x 95 mm
Power requirements	100-240 V AC ± 10%, 50/60 Hz
Connectivity technology	Wired
Serial interface type	RS-232
Noise level	28 dB
Power consumption (standby)	5.5 W
Power consumption (typical)	236 W
Operating temperature (T-T)	5 - 35 °C

Weight and Dimensions

Weight	3600 g