You can change the projected image in the following two ways.
• Changing by Source Search
The projector automatically detects signals being input from connected
equipment, and the image being input from the equipment is projected.
• Changes to the target image.
You can use the Remote Control buttons to change to the target input
port.
Automatically Detect Input Signal and Change the
Projected Image (Source Search)
You can project the target image quickly as input ports with no image
signal being input are ignored when you change by pressing the [Source
Search] button.
A
Computer1
B
Computer2
C
S-Video
D
Video
E
USB Display
F
USB: When image is from a device connected to USB (TypeA) Port.
G
LAN: When the projector is connected to a computer via a network,
and images from EasyMP Network Projection are projected.
Skipped when no image signal is being input.
Only EB-826WH/825H/824H/85H can switch to USB.
Only EB-826WH/825H/85H can switch to LAN.
Procedure
When your video equipment is connected, start playback before this
operation.
Using the Remote Control Using the Control panel
When two or more pieces of equipment are connected, press the [Source
Search] button until the target image is projected.
Changing the Projected Image
16
To Next Page
Loading...
Need help?
General
