When the Mail Notification function is set to On and a problem/warning
occurs in the projector, the following e-mail will be sent.
Subject: EPSON Projector
Line 1: The Projector Name where the problem has occurred
Line 2: The IP Address set for the projector where the problem has
occurred.
Line 3 and on: Details of the problem
The details of the problem are listed line by line. The following table shows
the details that are given in the message for each item. To deal with
problems/warnings, see "Reading the Indicators".
s p.80
Message Cause
Internal error Internal Error
Fan related error Fan Error
Sensor error Sensor Error
Lamp cover is open. Lamp Cover Open
Lamp timer failure Lamp Failure
Lamp out Lamp Error
Internal temperature error High Temp Error
(Overheating)
High-speed cooling in progress High Temp Warning
Lamp replacement notification Replace Lamp
No-signal No Signal
No Signal is input to the projector. Check
the connection status or check that the
power for the signal source is turned on.
Auto Iris Error Auto Iris Error
Message Cause
Power Err. (Ballast) Power Err. (Ballast)
A (+) or (-) appears at the start of the message.
(+): A projector problem has occurred
(-): A projector problem has been dealt with
Reading Problem Mail Notification Function (EB-826WH/825H/85H/84H/84L Only)
91
To Next Page
Loading...
Need help?
General
