Wired LAN menu
Sub Menu Function
IP Settings
You can make settings related to the following addresses.
DHCP
g
: Select whether or not (On/Off) to use DHCP. If this is set to On you cannot set any more addresses.
IP Address
g
: You can input the IP Address assigned to the projector. You can input a number from 0 to 255 in each field of the address. However, the
following IP Addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Subnet Mask
g
: You can input the Subnet Mask for the projector. You can input a number from 0 to 255 in each field of the address. However, the
following Subnet Masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Address
g
: You can input the IP Address for the gateway for the projector. You can input a number from 0 to 255 in each field of the address.
However, the following Gateway Addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
IP Address Display
To prevent the IP Address from being displayed on Network Info in the Network Menu and on the LAN Standby screen, set this to Off.
List of Functions
72
To Next Page
Loading...
Need help?
General
