Starting and closing Slideshow
Starting Slideshow
Procedure
A
Switch the projected image to USB. s p.16
B
When a USB storage device or digital camera is connected to
the projector, Slideshow starts.
s p.28
q
• You can also connect to the projector by inserting a memory card in
a USB card reader. However, some card readers may not be
compatible.
• When the following screen (Select Drive screen) is displayed, press
the [
] or [ ] buttons or the [a] or [b] buttons on the Control
panel to select the drive you want to use, and then press the [Enter]
button.
• To display the Select Drive screen, position the cursor on Select
Drive in the top half of the File List screen, and then press the
[Enter] button.
Closing Slideshow
Procedure
To close Slideshow, disconnect the USB device connected to the
projector's USB (TypeA) port. For digital cameras, hard disks, and so
on, turn off the power of the device and then disconnect.
Slideshow basic operations
The following describes the procedures for playing images using Slideshow,
and projection operations.
Procedure
A
Press the [ ], [ ], [ ], or [ ] buttons or the [w],
[
v], [a], or [b] buttons on the Control panel to position the
cursor on the file or folder you want to access.
A
Cursor
Presentations Using Slideshow (EB-826WH/825H/824H/85H)
23
To Next Page
Loading...
Need help?
General
