Others menu
EB-826WH/825H/85H EB-84H/84L
Sub Menu Function
SNMP
g
Set this to On when connecting to an environment under SNMP
g
control.
Trap IP Address 1
Trap IP Address 2
You can register up to two IP addresses for the
SNMP
g
trap notification destination.
You can input a number from 0 to 255 in each field of the address.
However, the following IP Addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
To use SNMP to monitor the projector, you need to install the SNMP manager program on your computer. SNMP should be managed by a network
administrator.
Priority Gateway
(EB-826WH/825H/85H only)
For the priority gateway, select either wireless or wired.
AMX Device Discovery
g
When the projector is connected to a network, set this to On to allow the projector to be detected by AMX Device Discovery. Set this to Off if you are not
connected to an environment controlled with a controller from AMX or AMX Device Discovery.
List of Functions
74
To Next Page
Loading...
Need help?
General
