Notes on operating the Network menu
Selecting from the top menu and sub menus, and changing of selected
items are the same as operations in the Configuration Menu.
When done, make sure you go to the Complete menu, and select one of
Yes, No, or Cancel. When you select Yes or No, you return to the
Configuration Menu.
Yes: Saves the settings and exits the Network menu.
No: Does not save the settings and exits the Network menu.
Cancel: Continues displaying the Network menu.
Soft keyboard operations
The Network menu contains items that require input of alphanumerics
during setup. In this case, the following software keyboard is displayed. Use
the [
], [ ], [ ], and [ ] buttons on the Remote Control or
the [
w], [v], [a], and [b] buttons on the Control panel to move the
cursor to the desired key, and then press the [Enter] button to enter the
alphanumeric. Enter figures by holding down the [Num] button on the
Remote Control, and pressing the numeric buttons. After inputting, press
[Finish] on the keyboard to confirm your input. Press [Cancel] on the
keyboard to cancel your input.
Each time the [CAPS] key is selected, it sets and changes between upper
case and lower case letters.
Each time the [SYM1/2] key is selected, it sets and changes the symbol keys
for the section enclosed by the frame.
List of Functions
66
To Next Page
Loading...
Need help?
General
