Resetting the Lamp Hours
The projector records how long the lamp is turned on and a message and
indicator notify you when it is time to replace the lamp. After replacing the
Lamp, make sure you reset the Lamp Hours from the Configuration Menu.
s p.77
q
Only reset the Lamp Hours after the Lamp has been replaced.
Otherwise the Lamp replacement period is not indicated correctly.
Replacing the Air Filter
Air filter replacement period
It is time to replace the air filter when:
• There is a tear in the air filter.
• The message is displayed even though the air filter has been cleaned.
How to replace the air filter
The air filter can be replaced even when the projector is suspended from a
ceiling.
Procedure
A
After you turn off the projector's power and the confirmation
buzzer beeps twice, disconnect the power cable.
B
Open the air filter cover.
Slide the air filter cover open/close switch, and open the air filter
cover.
C
Remove the air filter.
Grip the tab in the center of the air filter, and pull it straight out.
Replacing Consumables
99
To Next Page
Loading...
Need help?
General
