Using the Remote Control Using the Control panel
q
You can save at 400 ^ 300 dots in size.
E
When "Select this image?" is displayed, select "Yes".
F
Select the zoom factor from the zoom setting screen.
G
When the message "Save this image as the User's Logo?" is
displayed, select "Yes".
The image is saved. After the image has been saved, the message
"Completed." is displayed.
q
• Once a User's Logo has been saved, the logo cannot be returned to
the factory default.
• Saving the user's logo may take approximately 15 seconds. Do not
use the projector or any connected equipment while it is saving,
otherwise malfunctions may occur.
Saving a User's Logo
53
To Next Page
Loading...
Need help?
General
