• You can save at the size of the projector screen.
• If a part of the projected image is missing (because the computer
screen is larger than the projected screen), a selection area is
displayed, and you can select the area you want to use as the
User Pattern.
When "Select this image?" is displayed after making your selection,
select "Yes".
Using the Remote Control Using the Control panel
• When you press the [Enter] button on the Remote Control or the
Control panel, the screen size may change according to the signal
as it changes to the resolution of the image signal.
E
When the message "Do you save this image as the User
Pattern?" is displayed, select "Yes".
The image is saved. After the image has been saved, the message "The
User Pattern setting is complete." is displayed.
q
• Once a User Pattern has been saved, the logo cannot be returned to
the factory default.
• Saving the user pattern may take approximately 15 seconds. Do not
use the projector or any connected equipment while it is saving,
otherwise malfunctions may occur.
Saving a User Pattern
55
To Next Page
Loading...
Need help?
General
