The message "Not supported" is displayed.
Check Remedy
Is the image signal format setting correct?
Only when projecting images from a video source
Change the setting according to the signal for the connected equipment. s Signal Menu - Video Signal p.59
Do the image signal Resolution and the Refresh Rate correspond to
the mode?
Only when projecting computer images
Refer to the computer's documentation for how to change the image signal Resolution and the Refresh Rate output from
the computer. s "Supported Monitor Displays" p.107
"No Signal" is displayed.
Check Remedy
Are the cables connected correctly? Check that all the cables required for projection are securely connected. s Quick Start Guide
Is the correct input port selected? Change the image by pressing the [Source Search] button on the Remote Control or the Control panel. s p.16
Is the power for the computer or video source turned on? Turn the power on for the equipment.
Are the image signals being output to the projector?
Only when projecting images from a laptop computer or a computer
with a built-in LCD screen
If the image signals are only being output to the computer's LCD monitor or to the accessory monitor, you need to
change the output to an external destination as well as the computer's own monitor. For some computer models, when
the image signals are output externally, they no longer appear on the LCD monitor or accessory monitor.
s
Computer's
documentation, under a title such as "External output" or "Connecting an external monitor". If the connection is made
while the power of the projector or computer is already turned on, the function [Fn] key that changes the computer's
image signal to external output may not work. Turn the power for the computer and the projector off and then back on
again.
Images are fuzzy or out of focus
Check Remedy
Is the focus adjusted correctly? Turn the Focus ring to adjust the focus. s Quick Start Guide
Is the projector at the correct distance? Is it projecting outside of the recommended projection distance range?
Setup within the recommended range. s p.102
Is the Keystone adjustment value too large? Lower the projection angle to reduce the amount of keystone correction. s Quick Start Guide
Problem Solving
85
To Next Page
Loading...
Need help?
General
