EMP-9000/8000
2-28Revision:A SEIKO EPSON
2.10. RC Receptor Board Assembly
Detects the infrared rays signal from the remote controller. The receptor board assembly is
attached to the ballast unit (the front side) and lamp cover unit (the rear side).
The receptor board assembly is shown in Figure2-29.
Figure2-29 Receptor board assembly
The receptor board assembly signal is being jointed the cable to CN1405 (the front)/CN1002
(the rear) of the main board ASSY unit and the output signals and Repeater input signal (the
serial data) from both receptor board assemblies are an information retrieval decoder and be
converted to 16 bit parallel data.
1. The Main board Assy unit performs the power ON/OFF operation and the starting up
menus, utilizing the serial data received from the remote controller (button switches and
pointers).
2. The serial signal send to the Driver board Assy via the Main board Assy unit performs the
display control (Freeze / Blank/etc.).
3. The serial signal send to the AU board via the Main board Assy unit performs the audio vol-
ume control.
Circuit block
Figure2-30
Lamp cover unitBallast unit
Receptor board
(Front)
Receptor board
(Rear)
Main board Assy unit
Remote controller
RC Receptor board
Assembly
Receiver
IF unit
CN1405
CN1002
CN1502
CPU
(IC1101)
Address, I/O
Bus controller
(IC1108)
IR decoder
(IC1507)
SDA/SCK
CN302 CN303
AU board
Assembly
Driver board Assy
To Next Page
Loading...
