EMP-9000/8000
3-6Revision:A SEIKO EPSON
3.2.2. Lamp Cover Unit
1. Loosen two Lamp Cover Unit fixing screws(Screw, CP M3x6) and take out Lamp Cover Unit
from the back of the main frame.
Figure3-2
2. Remove RC Receptor Board Assembly and Connector Board L Assy on the Lamp Cover
Unit. Each is fixed in a screw(Screw, CBP-tite M3x8) individually.
Figure3-3
3. Remove Four screws(Screw, CBP-tite M4x35) fixing the Exhaust Fan then detach the Fan
Gard and Exhaust Fan.
Connector board L Assy
RC receptor board
assmbly
To Next Page
Loading...
