Epson EMP-8000 - Page 82

EMP-9000/8000
3-12Revision:A SEIKO EPSON
2. Remove two screws(Screw, CBP-tite M3x8) fixing the IF unit, then detach IF unit.
Figure3-12
3. Remove fourteen screws fixing the IF Fixing Plate, and remove the BNC Reinforcement
Plate on the IF Fixing Plate.
Figure3-13
4. Separate IF Fixing Plate and IF Circuit Assy.



Caution:
When installing the IF unit, refer to 2.8 and confirm cable is wired correctly.
Screw (HSH)
Screw CBP-tite M3x8
Screw CP M3x6
Screw CBP-tite M3x8
BNC Fixing Plate
IF Fixing Plate