3-15
EMP-9000/8000
SEIKO EPSON Revision:A
4. Remove four screws(Screw, CB M4x20) fixing the Intake Fan A /Intake Fan Guard, then
detach the Intake Fan A /Intake Fan Guard on the Optical Engine base.
Figure3-18
5. Remove the four screws(Screw, CP(S-P1) M3x6) fixing the Lens shift Mechanical Unit, then
detach the PP Knob Mechanical Unit on the Optical Engine.
Figure3-19
Caution:
Projection Lens Unit can remove when it removed Front Case. Refer to about Disassembly
Procedure of Projection Lens Unit.
When installing the Intake Fan A, please confirm Intake Fan A attached to a correct direction.
(Side that attaches and seal have attached and side that has cable is the outside)
When installing the Lamp Connector Holder, please confirm Lamp Connector Holder attached
to a correct direction. Confirm attached like the rough figure While seeing from the side of
Lamp insert entrance.
Screw
Screw
Screw
Screw
To Next Page
Loading...
