126
Saving a User's LogoSaving a User's Logo
User’s Guide
Select "Yes" in the sub-menu, and then press the
[Enter] button on either the remote control or the
projector's control panel.
The image to be recorded and a selection marquee
box will be displayed, so move the marquee box to
select the part of the image to use.
Tilt the [ ] button on the remote control or press the [ ],
[ ], [ ] and [ ] buttons on the projector's control panel to
select the part of the image to use as the user's logo, and then
press the [Enter] button on either the remote control or the
projector's control panel.
3
TIP
If "Yes" is accepted, since the image will be projected at their original
image signal resolution, images with the different resolution from the
projector's and video images will be projected at different size.
4
TIP
User's logos can be saved at up to 480 × 360 dots in size.
To Next Page
Loading...
