127
Saving a User's LogoSaving a User's Logo
User’s Guide
Select "Yes" at the confirmation screen, and then
press the [Enter] button on either the remote control
or the projector's control panel.
Select the zoom rate in the zoom rate setting screen,
and then press the [Enter] button on either the remote
control or the projector's control panel.
Select "Yes" at the confirmation screen, and then
press the [Enter] button on either the remote control
or the projector's control panel.
The image will then be saved. Once the image has been saved,
the message "Completed." will be displayed.
5
6
7
• Saving the user's logo may take a few moments (about 15 seconds).
Do not use the projector or any other sources which are connected to
the projector while the user's logo is being saved. If this is not
observed, it may result in errors in projector operation.
• Once a user's logo has been saved, the logo setting cannot be
returned to the factory default.
Caution
To Next Page
Loading...
