Network Software 127
Network Guide
IPX Trap
Printing Control
Timeout
Printing
Items Explanations
Trap Enable or Disable the trap.
Address Enter Network Address and Node Number (MAC Address)
of the server to which the trap is transmitted.
Format:
Network Address: Node Number
Suppose Network Address is A7E00BB0 (hexadecimal) and
Node Number is 000048930000 (hexadecimal). In this
case, the address is A7E00BB0:000048930000.
Community Enter the community name (up to 32 characters).
Socket Number Enter the Socket Number of the receive host, in
hexadecimal(0-FFFF).
Items Explanations
Printing Control Enable or Disables the printing control.
Printer Access Control Select Allow or Deny. Selecting Allow permits the network
access from the IP addresses registered on the printer
access control list. On the other hand, selecting Deny
blocks the network access from the IP addresses
registered on the printer access control list.
Printer Access Control List Enter the IP address ranges by which the network access
is restricted.
Items Explanations
Change Timeout Value Select this check box when you set the values before a
timeout occurs.
LPR Set the length of time for LPR before a timeout occurs
(between 0 and 3600 seconds). Enter 0 not to apply the
timeout.
RAW (Port9100) Set the length of time for RAW (Port9100) before a timeout
occurs (between 0 and 3600 seconds). Enter 0 not to
apply the timeout.
IPP Set the length of time for IPP before a timeout occurs
(between 0 and 3600 seconds). Enter 0 not to apply the
timeout.
To Next Page
Loading...
