112
Scanner Maintenance
5. Slide the transportation lock at
the back of the scanner to the
LOCK
position.
If the carriage does not
automatically return to the home
position, slowly raise the front of
the scanner and hold it up until
the carriage comes to rest in the
home position. Then slide the
transportation lock to the
LOCK
position.
If you are using a transparency unit and it is switched on, the scanner
carriage will not move to the home position. Remove the transparency
unit first, then perform the steps above. See the next section for
instructions.
locked position
1680.book Page 112 Thursday, March 1, 2001 4:28 PM
To Next Page
Loading...
