Epson L4160 series - Making Wi-Fi Settings by Push Button Setup

Related Information
& “Entering Characters” on page 18
& “Checking the Network Connection Status” on page 27
& “When You Cannot Make Network Settings” on page 135
Making Wi-Fi Settings by Push Button Setup
You can automatically set up a Wi-Fi network by pressing a button on the access point. If the following conditions
are met, you can set up by using this method.
❏ e access point is compatible with WPS (Wi-Fi Protected Setup).
❏
e
current Wi-Fi connection was established by pressing a button on the access point.
Note:
If you cannot nd the button or you are setting up using the soware, see the documentation provided with the access point.
1.
Select Wi- Fi S e tu p on the home screen.
To select an item, move the focus to the item using the
u d l r buttons, and then press the OK button.
2.
Select Wi-Fi (Recommended).
3. Press the OK button.
4. Select Push Button Setup (WPS).
5. Hold down the [WPS] button on the access point until the security light ashes.
If you do not know where the [WPS] button is, or there are no buttons on the access point, see the
documentation provided with your access point for details.
6. Press the OK button on the printer's control panel. Follow the on-screen instruction hereaer.
Note:
If connection fails, restart the access point, move it closer to the printer, and try again. If it still does not work, print a
network connection report and check the solution.
Related Information
& “Checking the Network Connection Status” on page 27
User's Guide
Network Settings
25