Epson L4160 series - Page 40

3. Load paper at the center of the paper support with the printable side facing up.
c
Important:
❏ Do not load more than the maximum number of sheets
specied
for the paper. For plain paper, do not load
above the line just under the
d symbol inside the edge guide.
❏ Load paper short edge rst. However, when you have set the long edge as the width of the user dened size,
load paper long edge rst.
❏ Pre-punched paper
Note:
❏ Load a single sheet of dened size plain paper with binding holes at the le or right.
❏ Adjust the print position of your le to avoid printing over the holes.
❏ Automatic 2-sided printing is not available for pre-punched paper.
4. Slide the edge guides to the edges of the paper, and then close the feeder guard.
c
Important:
Do not place objects on the feeder guard. Doing so may prevent paper from feeding.
5.
On the control panel, set the size and type of the paper you loaded in the rear paper feed.
To select an item, move the focus to the item using the
u d l r buttons, and then press the OK button.
User's Guide
Preparing the Printer
40