Epson LQ-570e - Page 100

EPSON LQ-570e/LQ-580 Revision C
Adjustment Adjustment and Resetting the Printer
1
00
Figure 5-6. Alignment Pattern Sample
2. Select most closely aligned number by pressing LF/FF ( ↓ ) and Load/Eject ( ↑ )
switches.
Font LEDs show the pattern number which is selected at that time. The selection is
advanced one by one as the switch is pressed, and the combination of On/Off/Blink of
these three LEDs is also changed according to the selection.
3. Fix the selected number by pressing Font switch.
Selected number is fixed and next alignment pattern is printed.
4. Repeat (2) to (3) until finishing Bi-d. adjustment for LQ mode.
Following adjustment is executed.
1. Bi-d. adjustment for draft mode.
2. Bi-d. adjustment for draft copy mode.
3. Bi-d. adjustment for LQ mode.
5. Turn the printer off.
The setting is stored into non-volatile memory.