Epson LQ-570e - Adjustment Overview; Required Adjustment; Adjustment Tools

EPSON LQ-570e/LQ-580 Revision C
Adjustment Adjustment Overview
9
4
5.1 Adjustment Overview
5.1.1 Required Adjustment
This section describes what adjustments are required after any part is removed or replaced.
The following table shows the relationship between the repair item and the adjustment.
NOTE: “ ¡ “means adjustment is required.
“---“means adjustment is not required.
5.1.2 Adjustment Tools
The following table shows the tools required for each adjustment.
Table 5-1. Required Adjustment
Required Adjustment
Parallel
Adjustment
Platen Gap
Factory
Setting
Bi-D
Adjustment
Printhead Removal or Replacement ---
¡ --- ¡
Printer Mechanism Replacement --- --- --- ¡
Printer Mechanism Removal --- ¡ --- ¡
Main Boar Replacement --- --- ¡ ¡
Timing Belt Replacement --- ¡ --- ¡
Platen Replacement ¡ ¡ --- ---
Carriage Assembly Replacement ---
¡ --- ¡
CR Motor Replacement --- --- --- ¡
EEPROM Clear --- --- --- ¡
Table 5-2. Required Adjustment Tool
Adjustment Required Tool ASP Code
Platen Gap Thickness gauge -
Factory Setting Program disk (Q80A10V) -
Parallel Adjustment Platen Parallelism Measuring Fixture (#F735) 1054655
Bi-D Adjustment N/A -